A method for distributing email notifications of assignment submissions, etc. to only some faculty members in courses with multiple faculty members.

Overview
Normally, when a student submits an assignment in a course for which multiple teachers are assigned as instructors, the notification is sent to all the instructors in charge of the course (if the notification setting is enabled). However, if you are teaching multiple classes in one course, you may want to send notification emails only to specific teachers. You can do this by setting up groups and groupings as follows.

Setup procedure

The following are the steps for setting up “issues” and “groups” and “groupings”.

1.Create multiple groups containing the faculty members you want to notify and the students who will perform the activity.

<Example>
Group α: Student Taro 6, Student Taro 7 + Teacher Taro 4
Group β: Student Taro 8, Student Taro 9 + Teacher Taro 5

memo
See below for basic instructions on how to create a group.
05-03.Create group05-03

2.Set the grouping.
<Example>
All groups: Groups α and β set in 1. above (All = students Taro 6 to 9 + teachers Taro 4 and 5)

3.In the “Assignment” content settings screen, configure the following
(a) Set “Notify > Notify Grader of Submission” to “Yes”.
(b) Select “Module Common Settings → Group Mode → Separate Group (Only group members can view)”.
(c) Set the grouping “All Groups” that you set earlier in “Module Common Settings → Grouping”.

 

With the above settings, you will only receive notifications when a student in the relevant group submits an assignment.

Example: When a student Taro 6 submits an assignment, only Taro 4 will receive the notification (i.e. Taro 5 will not receive the notification).

 

Attention

Be sure to set a separate group in 3.(b) above. If you select a visible group, notification e-mails will be sent to all faculty members registered for that course.

 

Last Updated on 2022-12-23

Did it help you?

Good  No good

0 out of 0 people said that this help was helpful.

ページの先頭へ